<rp id="tjhlf"></rp>

        <form id="tjhlf"><nobr id="tjhlf"></nobr></form>

          <b id="tjhlf"><address id="tjhlf"><form id="tjhlf"></form></address></b>

            青島海利佳紡織機械有限公司

            Home> News

            News Details

            What are the causes of common faults of computerized quilting machine? How to exclude?

            Posted by:Hailijia  Time:2020/3/30 13:59:57

             Fault phenomenon 1: the x-axis and y-axis sound is abnormal, the speed is slow, and the size is not in place when sewing and idling (shorter)

            Cause:
            Causes of phase loss of stepping motor: 1. Drive power supply itself; 2. Wire break in metal tube
            Exclusion method:
            Press F5 to enter the system test to check the x-axis and y-axis respectively, and find out the corresponding driver, metal tube or Z60 synchronous belt toothed ring
            Symptom 2:
            1. When sewing normally, x-axis and y-axis cannot operate normally (walking slowly)
            2. The needle bar does not return to the upper needle position during suspension
            3. F5 enters the system test, and the needle position does not change by 0 or 1
            Cause:
            1. Photoelectric sensor damaged
            2. Heavy nose
            3. Belt is too loose
            Exclusion method:
            1. Replace the photoelectric sensor. When replacing, leave a small section of wire for the damaged sensor for installation
            2. Check the bearings of the machine head, adjust the screws to make the main shaft concentric, and check whether the nylon gear falls
            3. Replace the tension belt or the main shaft belt is loose, etc
            Print this page 】 【close
            日本黄色视频在线

              <rp id="tjhlf"></rp>

                  <form id="tjhlf"><nobr id="tjhlf"></nobr></form>

                    <b id="tjhlf"><address id="tjhlf"><form id="tjhlf"></form></address></b>